There is no need to open the DesignModuler over and over again if the dimension(s) need to be changed. Just click this option and a P will appear, meaning that this dimension has been parameterized and you can change it directly by opening the parameter table (seen directly on ANSYS Workbench window). Until ANSYS 15, DesignModeler is the only. There might be an option to parameterize these dimensions but I am not aware of it maybe you can access online website of SpaceClaim to check how that can be done if it is possible.įor DesignModuler in ANSYS, it is easy to parameterize the dimensions. 7 As mentioned in 1.1.42, page 13, Workbench provides two geometric modelers: DesignModeler and SpaceClaim. As far as I can recall, you have to manually open the SpaceClaim everytime and then change these parameters manually. The problem with SpaceClaim, as I have observed, is that you cannot parameterize these dimensions. Then you can click on any edge, circle etc that you have sketched and change its dimension on the bottom left tree under 'General', as shown in the picture below. After making that sketch, you can click the option 'Dimensions' which can be seen in toolbar under 'Sketch' ribbon on top. I am going to assume you already know how to draw the sketch in SpaceClaim. If you need help in choosing the proper used workbench for your specific needs, our experienced sales staff will be glad to assist throughout the entire process. On top of that, watch videos uploaded by other channels as which explains other SpaceClaim features in detail. To view the logfile, see Extensions / View Log File.If you are new to ANSYS and SpaceClaim, then the first thing you should do is just open YouTube, open ANSYS Learning Channel and watch the tutorials for SpaceClaim there.All files created by CFturbo can be viewed in the workbench.CFturbo export updates can be performed for the complete CFturbo system by selecting Update in the right-click menu of the CFturbo system header.A SpaceClaim session that is connected to ANSYS Workbench is closed when the. Workbench (Mechanical) is more graphics focused and geometry focused.
Geometry preparation is performed, but currently no Named Selections are available. ANSYS, ANSYS Workbench, Ansoft, AUTODYN, EKM, Engineering Knowledge Manager. Whereas spaceclaim is the more advanced modeler with a greater GUI than that of DM. PARASOLID : The conversion option has to be used mandatory. If it is active, geometry exports in *.stp format are converted to SpaceClaim's *.scdoc file type, which includes Named Selections of relevant geometry features. STEP : The conversion option is optional. This option applies to all SpaceClaim exports from CFturbo and can be set in the Project Schematic properties of the CFturbo setup cell (" Convert *.stp to *.scdoc").
The CFturbo Workbench extension provides an option to process the geometry in SpaceClaim. 43.
0 kommentar(er)
